Schmartboard QFN EZ Board, 12-24 Pins, 0.5-0.65mm Pitch USA 202-0016-01 NEW

The 202-0016-01 supports a 16 Pin QFN .65mm Pitch and 12, 20 and 24 Pin QFNs with a .5mm Pitch.  The board also support 29 pieces of 0603 package and through hole components.

This product utilizes the “EZ” technology to assure fast, easy, and flawless hand soldering.

The GND (ground) busses (upper left/right corner and lower left/right corner) on the front of the board are electrically connected to each other and to a single ground plane on the back.

The back of the board is a copper GND plane.  There is a ground plane pad for each IC pin designed to accommodate 0603 footprint for easy installation of a decoupling capacitor or other part.

Once upon a time it was easy to prototype a circuit by hand soldering components on to a prototyping board, using wire wrap techniques or a breadboard.  Today, our advanced electronics require the use of small and tight pitched components.  It’s made it almost impossible to prototype.  Schmartboard, and only Schmartboard, has solved this conundrum. Never before has it been so easy to hand solder surface mount components.  Only Schmartboard has a patented technology that makes this possible.  “Schmartboard|ez” makes it easy to solder SOIC, QFP, QFN and other component packages with  pitches as small as .4mm.

Schmartboard’s also connect together.  Schmartboard allows you to wire up multiple Schmartboards and then mechanically connect them via our “SchmartBridges”.  Schmartboard’s “Electronic Circuit Building Block” patented technology makes it easier to create and trouble-shoot your circuit.  Rather than trouble-shooting an issue on a large and complicated messy circuit, why not build and test smaller circuit blocks and then connect them together to form your larger final circuit.  This saves time and money and is only available from Schmartboard.